Product Information
Value Case
For storing soft (hydrophilic), rigid gas permeable (RGP), or hard contact lenses during chemical disinfection. Store and use only during the chemical disinfection period. Do not use during high-temperature disinfection.
Detailed Ordering Information
How to Use
Wash the contact lens case with warm water before first use. Do not use soap, detergent, or other household chemicals. Rinse thoroughly with a sterile disinfectant solution after washing.
Fill the right lens cavity two-thirds full with fresh sterile disinfectant solution. Each time you store the lens, submerge the right lens cavity two-thirds full using only fresh contact lens disinfectant solution and securely close the lid.
Repeat the same procedure for the other lens cavity and lens.
Keep the lenses in the case for the time prescribed by your eye care professional. Before wearing, thoroughly rinse each lens with a sterile disinfectant solution, following the lens-specific recommendations. Rinse the lens case with sterile contact lens solution (do not use tap water). After use, open the lens case and leave it dry. Turn the case upside down and shake off any remaining solution. Make sure there is no solution left in the case before air-drying.
Replace the lens case at least once every three months. Contact lens cases can harbor bacterial growth. Consult the solution manufacturer's recommendations when disposing of solution after opening.
Do not expose contact lenses to water while wearing them.
Caution
Lens cases can be a significant source of microbial contamination. To prevent eye infections, wash, rinse, and air-dry your lens case daily.
Using multipurpose solution past its disposal date can contaminate the solution, which can lead to serious infections, vision loss, or blurred vision.
Heating the lens case can cause deformation. Use only for storage during chemical disinfection. Do not heat the case. If you experience eye inflammation, pain, or irritation while wearing your lenses, immediately remove them and consult an eye care professional.
Never refill old solution left in the case, as reuse can reduce the effectiveness of lens disinfection and lead to serious infection, vision loss, or blindness. Topping off simply adds new solution to the solution remaining in the case.
Do not store lenses or rinse the lens case with water or any non-sterile solution. Use only fresh, sterile solution to avoid contaminating your lenses or case. Using non-sterile solutions can lead to serious infection, vision loss, or blindness.
Do not heat the lenses in the disinfectant solution. It is not intended for heat disinfection. It is formulated for chemical disinfection only!
If the lens cavity is dry after the disinfection cycle, do not remove the lens. Fill the well with fresh saline solution. Close the cap tightly and wait 30-40 minutes for the lens to hydrate. If the lens cavity repeatedly dries out or leaks, replace the case.
Keep out of reach of children.
Ships from Korea
